Welcome to the KeepItPrinting.com forums! The doctor is IN.

          
                                                            

Your business can be seen here! Prime spots available!
             

Please consider making a voluntary donation if you find these forums helpful. Thank you.
Home of the Kip Doctor!            REGISTER: In order to register for our forums please send an E mail to kiptech@earthlink.net stating what user                                                               name and password you would like. This is now required due to all the spambots that have been registering.
KeepItPrinting.com Forum Index KeepItPrinting.com
The "unofficial' and "unauthorized" KIP info site.


Xerox 6050

 
Post new topic   Reply to topic    KeepItPrinting.com Forum Index -> Tech discussions on other makes
View previous topic :: View next topic  
newbe1
doctor


Joined: 20 Aug 2009
Posts: 273
Location: boise idaho

 PostPosted: Wed Mar 23, 2016 3:38 pm    Post subject: Xerox 6050 Reply with quote Back to top

Replaced bearing and gear kit it ran 5 prints then it jammed. Checked for obstructions found none. When it hits the fuser it curls up and that is why it's jamming. So I cleaned fuser roller witch has almost a million Sq ft on it along with pressure roller. Made sure that the bias clip was clean found no broken stripper fingers. Did run fuser motor and everything is working properly anyone have a similar problem
 
View user's profile Send private message
copyman96
dreaming of medical school


Joined: 04 Dec 2014
Posts: 6

 PostPosted: Tue Apr 12, 2016 2:16 pm    Post subject: Reply with quote Back to top

Prints may sometimes gets stuck in the middle of printing while in the fuser roller area, giving the customer a Clear Paper Path Upper Area message.

Check DC120 and DC122 and they will most likely show 8-200 fault code.

A Possible cause:

The Fuser Motion Sensor may be dirty.

Clean the sensor with film remover. This will help to remove the paper dust and may solve the problem.
 
View user's profile Send private message
newbe1
doctor


Joined: 20 Aug 2009
Posts: 273
Location: boise idaho

 PostPosted: Fri Apr 15, 2016 7:02 pm    Post subject: Reply with quote Back to top

Thanks Copyman for the reply i will give that a shot
 
View user's profile Send private message
newbe1
doctor


Joined: 20 Aug 2009
Posts: 273
Location: boise idaho

 PostPosted: Fri Oct 28, 2016 6:59 pm    Post subject: Reply with quote Back to top

hopefully this will help others the reason it was jamming after a pain staking search was the exit unit has a wire attached on left hand side and if you don't get it in the right position it keeps the exit assy open a little and jams.
 
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    KeepItPrinting.com Forum Index -> Tech discussions on other makes All times are GMT - 3.5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum